Primer
Pre-Prime 167
A high performance, two-component chemically-cured 100% solids epoxy penetrating sealer.
Filter by
Products
My Filters
Primer
Interbuild 1002
Interbuild 1002 is a high performance, two component epoxy primer with excellent chemical and abrasion resistance. It exhibits good penetration properties to ensure good adhesion on concrete floors. Interbuild 1002 is especially suited for properly prepared concrete substrates.
Primer
Intergard 361
A two pack, low temperature cure, epoxy universal primer which can be overcoated with various finish coats such as polyurethane, epoxy and alkyd finishes after extended periods, without the use of a tie coat. It is also used as a primer over galvanised steel and stainless steel.
Primer
Intershield 300V
A light coloured, abrasion resistant, aluminium pure epoxy coating giving excellent long term anticorrosive protection and low temperature application capability.
Primer
Cathacoat 304V
Two component solvent based inorganic zinc rich ethyl silicate based primer.Meets SSPC Paint 20 requirements.
Primer
Intergard 7500
A two component, high volume solids, abrasion resistant pure epoxy coating pigmented with aluminium that provides excellent long term anti-corrosive protection. Intergard 7500 is capable of fast cure and has low temperature cure properties. Ideally suited for use as a universal primer in protecting underwater areas, splashzones, decks and structural steel.
Primer
Interprime 4198
A one component, fast drying, high performance, universal alkyd primer pigmented with zinc phosphate. Suitable for use as a primer with single pack polysiloxanes.
Primer
Devprime 1403
A heavy duty, high quality, rust inhibitive alkyd primer for use over properly prepared steel. A high performance shop primer with high volume solids providing increased coverage rates and one coat application. *Please note this product is only available in North America.
Preconstruction Primer
Interplate 997
A two pack, heat resistant zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C (1472°F)), with minimum production of zinc salts. Suitable for high speed welding and cutting with excellent resistance to damage caused by welding, gas cutting and fairing thereby reducing secondary surface preparation requirements in comparison to typical zinc silicate products.
Primer
Interprime 1068
Interprime 1068 is an air drying Zinc Phosphate Primer designed for application to all types of steel surfaces. This primer is characterised by good anti-corrosive properties, easy application and the ability to protect hand cleaned steel. Interprime 1068 is primarily intended as a single coat system for use in mildly corrosive environments, classified in ISO12944-2 as up to and including C2.