A two component, high volume solids, abrasion resistant pure epoxy coaitng pigmented with aluminium that provides excellent long term anti-corrosive protection. Intergard 7500 is capable of fast cure and has low temperature cure properties. Ideally suited for use as a universal primer in protecting underwater areas, splashzones, decks and structural steel.

Specifically designed be embedded in the INTERCRETE range of cementitious coatings to provide a highly flexible impermeable seal over ‘live’ cracks and expansion or construction joints in waterproofing applications. Intercrete 4872 is a permanently elastomeric composite tape exhibiting over 600% elongation which enables rapid application of the INTERCRETE range. Provides excellent weathering resistance and is highly tolerant of a wide range of chemicals and is impermeable to water under 10 bar hydrostatic pressure (100m head of water).

Designed to remove light to medium rust deposits from a variety of surfaces. Suitable as a cleaning agent to remove rust stains in coated areas. Can be used as an alternative to traditional sandblasting, ultra-high pressure water blasting or power tool methods where these have been ruled out for operational, health and safety or environmental reasons. Effective for removal of corrosion on stainless steel structures and aluminium.

Specifically designed for the general purpose structural repair and reinstatement of concrete in single coat applications up to 80mm in a single layer. Intercrete 4800 offers low permeability to water at 10 bar positive and negative pressure along with excellent resistance to carbon dioxide gas and chloride ion diffusion. CE-marked in accordance with BS EN 1504-3, Class R3. Suitable for repair methods 3.1, 3.3, 7.1, 7.2 as defined in BS EN 1504-3.

Intertherm 2205 is a specialist temperature resistant maintenance coating, designed to resist corrosion under insulation (CUI) and high temperatures up to 230°C (446°F). Based on innovative, hot spread epoxy technology Intertherm 2205 shows excellent application characteristics and can be brush applied to hand prepared, hot steel up to 205°C (401°F).

For polymer modification of sand and cement mortars to provide enhanced mechanical characteristics: When mixed with cement, can be used as a primer and a bonding agent for polymer mortars, renders and screeds. Can also be diluted with water to produce a primer for roof and deck applications in the clean water industry. WRAS Approved for use in contact with potable water.

Enviroline 405HTR MR is a reinforced chemcial resistant system. The system features a high temperature reesistant, 100% volume high solids, two component polycyclamine cured lining topcoat. Fibre glass mat reinforcement increases physical properties and where necessary allows dynamic crack bridging in concrete. In the table below you can find System Sheet and Application guidelines. For Technical Datasheets and MSDSs please click on the links to the individual component products of the system below the table.

Interline 995 MR Flakeline is a reinforced chemical resistant system. The system features a glass flake filled novolac vinyl ester topcoat for long-term chemical and heat resistance and fibre glass mat reinforcement to increase physical properties and where necessary bridge dynamic cracks in concrete. In the table below you can find System Sheet and Application guidelines. For Technical Datasheets and MSDSs please click on the links to the individual component products of the system below the table.

Interline 984 MR is a reinforced chemcial resistant system. The system features a 100% volume high solids, two componentepoxy phenolic topcoat. Fibre glass mat reinforcement increases physical properties and where necessary allows dynamic crack bridging in concrete. In the table below you can find System Sheet and Application guidelines. For Technical Datasheets and MSDSs please click on the links to the individual component products of the system below the table.